Parts, Chemicals & Accessories for your Hot tub & Spa
£168.00

Hot tub heater assembly, Balboa 3.0KW M7 Heater With Studs - Plastic box.

Hot tub heater assembly, Balboa 3.0KW M7 Heater With Studs  - Plastic box.

240v 15" x 2" Complete Heater inc Sensors, Seals & Element

Replacement for Parts Coded: 58107, 58141, 58118 (GL and GS Heaters).

Built in the Factory

Although the studs can be cut off easily, this heater tube comes with 2 studs, 1 on top and 1 below to enable it to be easily fitted inside the controller box.

This heater tube is factory made and comes complete with a new 3kw element and a matching pair of Balboa 12" M7 sensors, it is made from Titanium, which means it can withstand even the harshest chemical, pressure and heat environments.

When replacing an heating tube for anything except its age please remove the cause of the fault, i.e. wrong chemicals being used incorrectly or restriction of water flow (blocked filters or pump failure)

This heater tube is used on 'plastic Balboa control box's', call if you need more information

Connections: Fits 2" Tail Pieces

Element: 3KW

 

Power: Volts: 230
             Hz: 50
             KW: 3.0


Amps:  11.5-12.0

Specification: Sensor compatibility: M7 24" x 2
                       Material spec: Incoloy
                       Required flow rate: 21gpm
                       Flow detection: M7 Technology by using a sensor at each end of the heater                         assembly

Compatible with: GS500, GS500Z, GS501, GS501Z (with 3.0KW on label only),                                             GS501SZ, GS510, GS510S, GS510Z, GS510SZ, GS511SZ, GS523DZ,                               GL2000 mach 3, GL2001 mach 3 and more

Connections/Fixings: Usually held in with two fixing studs, one at the top and one                                                  underneath. 2"  plastic female sockets to connect to plumbing 

                                  Comes complete with tailpieces, 2 x Balboa M7 sensors Balboa                                            Heater seals and a factory fitted Element                          

Dimensions: Heater length: 15 inches
Heater Diameter:  2 inches
Between terminals: 1.25 inches
Overall length complete:19.5 inches