£120.00
Balboa 3.0KW M7 Heater With Studs - Plastic box, GL-GS
Hot tub heater assembly, Balboa 3.0KW M7 Heater With Studs - Plastic box.
240v 15" x 2" Complete Heater inc Sensors, Seals & Element
Replacement for Parts Coded: 58107, 58141, 58118 (GL and GS Heaters).
Built in the Factory
Although the studs can be cut off easily, this heater tube comes with 2 studs, 1 on top and 1 below to enable it to be easily fitted inside the controller box.
This heater tube is factory made and comes complete with a new 3kw element and a matching pair of Balboa 12" M7 sensors, it is made from Titanium, which means it can withstand even the harshest chemical, pressure and heat environments.
When replacing an heating tube for anything except its age please remove the cause of the fault, i.e. wrong chemicals being used incorrectly or restriction of water flow (blocked filters or pump failure)
This heater tube is used on 'plastic Balboa control box's', call if you need more information
Connections: Fits 2" Tail Pieces
Element: 3KW
Power: Volts: 230
Hz: 50
KW: 3.0
Amps: 11.5-12.0
Specification: Sensor compatibility: M7 24" x 2
Material spec: Incoloy
Required flow rate: 21gpm
Flow detection: M7 Technology by using a sensor at each end of the heater assembly
Compatible with: GS500, GS500Z, GS501, GS501Z (with 3.0KW on label only), GS501SZ, GS510, GS510S, GS510Z, GS510SZ, GS511SZ, GS523DZ, GL2000 mach 3, GL2001 mach 3 and more
Connections/Fixings: Usually held in with two fixing studs, one at the top and one underneath. 2" plastic female sockets to connect to plumbing
Comes complete with tailpieces, 2 x Balboa M7 sensors Balboa Heater seals and a factory fitted Element
Dimensions: Heater length: 15 inches
Heater Diameter: 2 inches
Between terminals: 1.25 inches
Overall length complete:19.5 inches